ISDN-4 - ISDN Interface for CS8014

The Test System CS8014 "Automatic FFT telephone test System" was designed to test Telephone terminals for PSTN lines. 
The ISDN-4 Interface, allows the CS8014 to extend effectively toward the ISDN telephone terminals the functional testing. Especially it can operate on TE terminals (telephones) or on PABX connected through the S Bus.
Through the ISDN-4 interface connected to CS8014 Test Equipment will be possible to make the most important functional tests required by the ETSI -CTR8 Standard.

More information about ISDN-4

VoIP-4 VoIP Telephone Adapter

VoIP-4 adapter, used with our CS8014 or CS6015 Telephone Tester, is the most economic solution to easily execute manual or automatic testing over VoIP and SIP Telephones.
Based on CS8030, the system becomes a true VoIP Conformance Tester able to test the requirements meeting TIA/EIA 810 and TIA 920 Standards other than European ETSI Standard. 

Hardware requirements for using the VoIP-4 are:

•  CS8014 must be equipped with SGN-OPT+CLIP option.

•  CS6015 must be equipped with Actuators option.

•  CS8030 must be equipped with Special User Interface Option and in rel. 1.7.0

  More information about VoIP-4

CS2037 - Din Expander

This device allows the connection of the acoustic devices to the CS8014. Normally, there are 2 din connectors for two Test Heads and two Sound Level Meters. By using the CS2037, you can connect up to four Test Heads.

CS2035 - Console for CS8014 Remote Control

The Console for Remote Control of CS8014 is used only when in stand-alone mode. On the front panel there are the executive keys such as start, continue, repeat, etc. The CS2035 also presents a typical Italian telephone connector in addition to three other kinds of FCC connectors for the telephone set under test coupling.

CS2035W - Console for PC Remote Control

The CS2035W is a little keyboard for host Personal Computers which controls the CS8014 Test System. 
The Operator controls the functions of CS8014, using the executive keys associated with the WIN8014 software application.

ZX-1 - Telephone-line Termination Box

ZX-1 is a helpful accessory for CS8014 to make quickest and easiest the telephone testing involving a lot of line termination impedance changes. ZX-1 has internally up to four telephone-line termination impedances.
If you connect ZX-1 to the "actuators" connector of CS8014, through the supplied cable, and if you switch ZX-1 on "actuators" position, you obtain an automatic selector for telephone-line impedance. That, provided you inserted in your test program two "actuator" pseudo-test, the first one, before the test requiring the termination impedance, activating the appropriate relay (see at the table below), the second one to de-activate it, after.